?、?￠220±10VAC50/60HZ，采用單相5~1三圓腳插頭，包含一條接地線；

　?、?1 ￠ 220 ± 10VAC50/60HZ, using single-phase 5~1 three round pin plug, including one grounding wire;

　　②3￠380±10V50HZ，采用三相四線制直接出線方式，五芯雙絕緣電纜，包含一條接地線；

　?、?3 ￠ 380 ± 10V50HZ, using a three-phase four wire direct outgoing method, a five core double insulated cable, including one grounding wire;

　　③用戶配備的電源線線徑需等于或大于超聲波清洗機引線線徑；

　?、?The power cord diameter provided by the user must be equal to or greater than the lead wire diameter of the ultrasonic cleaning machine;

　　2、接地線：本公司生產超聲波清洗機機體及發生器都會在其電源引線上配有的接地線，并有明區分于其它電線的特征，因為本設備與水、腐蝕性（溶脹性）液位接觸，易引起漏電，請按安全要求接好接地線；

　　2. Grounding wire: The ultrasonic cleaning machine body and generator produced by our company are equipped with grounding wires on their power leads, which have distinct characteristics from other wires. Because this equipment comes into contact with water and corrosive (swelling) liquid levels, it is easy to cause leakage. Please connect the grounding wire according to safety requirements;

　　3、設備采用不燃性洗凈劑，切勿采用易燃易爆物質作洗凈劑，設備的使用在必需確保遠離有易燃易爆物質的場合，用戶特殊情況下必需采用某些物質時，必須洽詢本司確認安全，并作好相應的安全防護措施；

　　3. The equipment uses non flammable cleaning agents and should not use flammable or explosive substances as cleaning agents. When using the equipment, it is necessary to ensure that it is kept away from places with flammable or explosive substances. If the user needs to use certain substances in special circumstances, they must consult our company to confirm safety and take corresponding safety protection measures;

　　4、洗凈槽中無液或液位不足都會對設備造成不可逆轉的破壞，使用時必需確保槽中注入足量的洗凈液，否則相關的電熱器、泵、 超聲波 震子都可能損壞并可能引超火災及人身傷害；

　　4. No liquid or insufficient liquid level in the cleaning tank can cause irreversible damage to the equipment. When using, it is necessary to ensure that a sufficient amount of cleaning liquid is injected into the tank, otherwise related electric heaters, pumps, and ultrasonic transducers may be damaged and may cause fire and personal injury;

　　5、電氣控制箱及相關電氣組件等注意不要濺入水，并遠離水蒸汽、腐蝕性氣體、粉塵等；

　　5. Be careful not to splash water into the electrical control box and related electrical components, and keep them away from water vapor, corrosive gases, dust, etc;

　　6、超聲波清洗機設備異常時請及時與我公司聯絡或停止電源后由有經驗的電工進行檢查；

　　6. When the ultrasonic cleaning machine equipment is abnormal, please contact our company in a timely manner or have an experienced electrician inspect it after stopping the power supply;

　　7、要清洗的工件請用有支腳的洗籃或掛具裝掛好，置入槽中洗凈，禁止將工件直接置入槽底進行洗凈，否則可能引起工件及缸底的損傷；

　　7. Please use a foot supported washing basket or hanging tool to hang the workpiece to be cleaned, and place it in the groove for cleaning. It is forbidden to directly place the workpiece at the bottom of the groove for cleaning, otherwise it may cause damage to the workpiece and cylinder bottom;

　　8、超聲波清洗機設備作業時，機體內可能存在高溫、高壓、電氣組件端子表面帶電、傳動機構的運動、壓力突動等可能的引起人身傷害的因素，工作時請勿打開機殼，以免在無防護條件下作業；

　　8. During the operation of ultrasonic cleaning equipment, there may be factors such as high temperature, high voltage, live electrical component terminal surfaces, movement of transmission mechanisms, and sudden pressure changes inside the machine body that may cause personal injury. Do not open the machine casing during operation to avoid working without protection;

　　9、設備長期不用時，請放出洗凈液，干燥內槽及表面后用薄膜保護好，以防止設備的腐蝕老化加快；

　　9. When the equipment is not in use for a long time, please release the cleaning solution, dry the inner tank and surface, and protect them with a thin film to prevent accelerated corrosion and aging of the equipment;

　　以上的精彩內容來自：全自動超聲波清洗機更多的精彩內容請關注我們的官方網站：http://m.6131420.com 我們會有更多精彩內容等您查看。

　　The above exciting content comes from: Fully automatic ultrasonic cleaning machine. For more exciting content, please follow our official website: http://m.6131420.com We will have more exciting content waiting for you to view.